Husqvarna 536LiP4 Operation Manual - Page 12
Cutting equipment
View all Husqvarna 536LiP4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
GENERAL SAFETY PRECAUTIONS Flashing warning indicator (3) and green LED (2) is lit could indicate that: • it is not possible to apply full power and, at the same time, activate the machine. Release the power trigger and the machine is active. • the machine is blocked. Deactivate the machine. Remove the battery from the machine. Pull the pole saw away from the kerf while lifting the branch. • the machine is overloaded due to heavy trimming. Release the power trigger and the machine is active. If the warning symbol (3) flashes, it indicates that the machine is too hot and the machine deactivates. When the machine is restored to normal temperature it is again ready to run and you can activate the machine. Solid red warning light (3) indicates service. Power trigger lockout The power trigger lockout is designed to prevent accidental operation of the power trigger. When you press the lock (1) (i.e. when you grasp the handle) it releases the power trigger (2). When you release the handle the power trigger and the power trigger lockout both move back to their original positions. This movement is controlled by two independent return springs. Cutting attachment guard Always use the recommended guard for the cutting attachment you are using. See chapter on Technical data. WARNING! Never use a cutting ! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury. WARNING! This machine is renowned for ! its low vibration load. Overexposure to vibration can lead to circulatory damage or nerve damage in people who have impaired circulation. Contact your doctor if you experience symptoms of overexposure to vibration. These symptoms include numbness, loss of feeling, tingling, pricking, pain, loss of strength, changes in skin colour or condition. These symptoms normally appear in the fingers, hands or wrists. Cutting equipment 1 2 Make sure the power trigger is locked when the power trigger lock is in its original position. Li-ion This section describes how you can achieve maximum clearing capacity and extend the life of the cutting attachment through correct maintenance and using the right type of cutting attachment. • Only use cutting equipment recommended by us! Press the power trigger and make sure it returns to its original position when you release it. • Keep the chain's cutting teeth properly sharpened! Follow our instructions and use the recommended file gauge. A damaged or badly sharpened chain increases the risk of accidents. Check that the power trigger and the power trigger lockout move freely and that the return spring works properly. • Maintain the correct raker clearance! Follow our instructions and use the recommended raker gauge. Too large a clearance increases the risk of kickback. See instructions under the heading Start. Start the machine and apply full power. Release the power trigger and check that the cutting attachment stops and remain at a standstill. 12 - English