Husqvarna MZ6128ZT Owners Manual - Page 27

equipped with Electronic Fuel Management

Page 27 highlights

7. Open the fuel tank valve. OPERATION WARNING! Engine exhaust and certain vehicle components contain or emit chemicals considered to cause cancer, birth defects or other reproductive system damage. The engine exhaust contains carbon monoxide, which is an odorless, colorless, poisonous gas. Do not use the machine in enclosed spaces. Fuel valve in the OPEN position 8. Press in and turn the ignition key to the start position. IMPORTANT INFORMATION Do not run the starter for more than 5 seconds each time. If the engine does not start, wait about 10 seconds before retrying. IMPORTANT INFORMATION The Briggs & Stratton engine on this unit is equipped with Electronic Fuel Management (EFM). The engine choke is automatically regulated during starting and warm up. Turn to the START position 9. When the engine starts, immediately release the ignition key back to the run position. 10. Set the desired engine speed with the throttle. Allow the engine to run at a moderate speed, "half throttle", for 3-5 minutes before loading it too heavily. USE FULL THROTTLE WHEN MOWING. 8065-013 80658-050 Release ignition to the RUN position 8066-008 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64

OPERATION
27
Press in and turn the ignition key to the start
8.
position.
Open the fuel tank valve.
7.
8065-013
Fuel valve in the OPEN position
80658-050
Turn to the START position
IMPORTANT INFORMATION
Do not run the starter for more than 5 seconds
each time. If the engine does not start, wait
about 10 seconds before retrying.
8066-008
Release ignition to the RUN position
When the engine starts, immediately release the
9.
ignition key back to the run position.
Set the desired engine speed with the throttle.
10.
Allow the engine to run at a moderate speed,
“half throttle”, for 3-5 minutes before loading it too
heavily. USE FULL THROTTLE WHEN MOWING.
WARNING!
Engine exhaust and certain vehicle
components contain or emit
chemicals considered to cause
cancer, birth defects or other
reproductive system damage. The
engine exhaust contains carbon
monoxide, which is an odorless,
colorless, poisonous gas. Do not use
the machine in enclosed spaces.
IMPORTANT INFORMATION
The Briggs & Stratton engine on this unit is
equipped with Electronic Fuel Management
(EFM). The engine choke is automatically
regulated during starting and warm up.