Husqvarna PZ 72 Owners Manual - Page 33

Running, pin into the desired hole. Release deck height

Get Husqvarna PZ 72 PDF manuals and user guides View all Husqvarna PZ 72 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

OPERATION Running 1. Release the parking brake by moving the lever downward. NOTE: The mower is equipped with an operator presence system. When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine. 2. Move the steering controls to the neutral position (N). Release the parking brake 3. The cutting height can be set from 1"- 5" (2.5 cm-12.7 cm) by setting the cutting height pin into the desired hole. Release deck height control by applying equal pressure to both pedals. 8065-006 Cut height selection pedals 4. Push foot pedal fully forward for transport position. Set pin at desired cutting height. (Pin is removed by rotating 180O.) Push pedals again to lower deck to selected setting. 8065-017 Set deck to selected cutting height 8065-016 33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
OPERATION
33
Running
1. Release the parking brake by moving the
lever downward.
NOTE: The mower is equipped with an
operator presence system. When the engine
is running, any attempt by the operator to
leave the seat without first setting the parking
brake will shut off the engine.
2. Move the steering controls to the neutral
position (N).
3.
The cutting height can be set from 1"- 5"
(2.5 cm-12.7 cm) by setting the cutting height
pin into the desired hole. Release deck height
control by applying equal pressure to both
pedals.
4.
Push foot pedal fully forward for transport
position. Set pin at desired cutting height. (Pin
is removed by rotating 180
O
.) Push pedals
again to lower deck to selected setting.
8065-006
Release the parking brake
8065-017
Cut height selection pedals
8065-016
Set deck to selected cutting height