Husqvarna PZ 72 Owners Manual - Page 46
Wheel and Deck Zerks, Front Wheel Mount, Front Wheel Bearings, Cables, Hydraulic Drive
View all Husqvarna PZ 72 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
LUBRICATION Wheel and Deck Zerks Use only good quality bearing grease. Grease from well-known brand names (petrochemical companies, etc.) usually maintains a good quality. Front Wheel Mount Remove dust cap to expose zerk. Lubricate with a grease gun until the grease is forced out around the top washer. Front Wheel Bearings Lubricate 3-4 strokes with a grease gun on each set of wheel bearings. Cables If possible, grease both ends of the cables and move the controls to end stop positions when lubricating. Refit the rubber covers on the cables after lubrication. Cables with sheaths will bind if they are not lubricated regularly. If a cable binds, it can disrupt operation. If a cable binds, remove the cable and hang it vertically. Lubricate it with light engine oil until the oil begins to escape from the bottom. Lubricating front wheels Hydraulic Drive Fluid and Filter Change The hydraulic drive is designed with an external filter for ease of maintenance. To ensure constant fluid quality levels and longer life, an oil filter change interval of every 500 hours is recommended. The following procedure can be performed with the pump installed in the vehicle, and the vehicle on level ground. 1. Lock the vehicle parking brake. 2. Place an oil drain pan with a 2 gallon capacity beneath the oil reservoir. Remove the drain port and drain oil. Remove the oil filter from the pump. Drain old oil filters of all free-flowing oil prior to disposal. Place used oil in appropriate containers and dispose of it in accordance with laws in your area. 2 3 1 1. Pump filter 2. Oil reservoir 3. Drain port Changing the hydraulic pump oil and filter 3. After the oil has drained, wipe the filter base surface off and apply a film of new oil to the gasket of the new replacement filter. 46 8065-032 8065-036