Husqvarna ST 430 Owner Manual - Page 24
T/430T only
View all Husqvarna ST 430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
If the adjustment does not resolve the problem, replace the auger belt. See To install the auger belt on page 22. To adjust the release cable of the discharge chute 1. To adjust the release cable, turn the cable adjuster until the release lever of the discharge chute does not move freely. 3. Loosen the cable adjusters ¼ turn to make the cables less tight. To remove the wheels 1. Remove the wheel pin (A) and the retainer pin (B). 2. Remove the wheel from the axle (C). A C To adjust the left and right discharge chute cables 1. Put the discharge chute lever in the center position. 2. Turn the cable adjusters until the discharge chute points straight forward, and the cables are tight. B To adjust the tension of the continuous tracks (for ST 424T/ 427T/430T only) Note: Tools that are necessary for this task: a 9/16" deep socket, a 9/16" wrench and a 5 kg (10 lbs) weight. 1. Loosen the locking screw (A) 1 turn. 24 876 - 011 - 11.05.2020