Husqvarna Z560LS Owner Manual - Page 20

To remove and install the front wheels 1. Remove the nut and the bolt to remove the front wheels from the forks. To adjust the parallelism of the cutting deck This procedure will set the cutting deck in a standard position. 1. Make sure that the tire pressure is correct. Refer to Tire pressure on page 19. 2. Park the product on a level surface. 3. Turn the outer blade tips to align with the cutting deck side to side. 2. Install in the opposite sequence. Torque the nut and bolt to 45 ft-lbs / 61 Nm. To adjust the anti-scalp rollers The anti-scalp rollers keep the cutting deck in the correct position on the ground and prevent lawn scalping in most terrain conditions. The anti-scalp rollers can be set in 3 positions for different lengths of grass: • Top position: 1.5-2.5 in. / 38-64 mm grass. • Middle position: 2.5-4 in. / 64-102 mm grass. • Bottom position: 4-5 in. / 102-127 mm grass. 1. Park the product on level ground and stop the engine. 2. Remove the nut, the bolt, the axle and the antiscalp roller. WARNING: The blades on the cutting deck are sharp and can cause injury. Use protective gloves. 4. Measure the distance between the ground and the bottom of the blade tip on the discharge side of the cutting deck. Make a note of the distance. 5. Measure the distance between the ground and the bottom of the blade tip on the side opposite to the discharge side. The distance must be the same as the distance for the discharge side. If adjustment is necessary, adjust the 2 front bolts until the 2 side to side distance are equal. 3. Install the anti-scalp roller in one of the 3 positions. CAUTION: The cutting deck can become damaged if the antiscalp rollers are incorrectly adjusted. The anti-scalp rollers must be approximately 1/4 in. / 6.4 mm from the ground. 20 2060 - 001 - 07.02.2023