IBM 09N4290 User Guide - Page 43

Chapter 3: Basic Operations 29 Password protecting the console 1. Set the password as described in the previous procedure. 2. Select Enable Screen Saver. 3. Type the number of minutes for Inactivity Time (from 1 to 99) to delay activation of password protection and the screen saver feature. 4. For Mode, select Energy if the monitor is ENERGY STAR® compliant, otherwise select Screen. ATTENTION: Monitor damage can result from the use of Energy mode with monitors not compliant with ENERGY STAR. 5. (Optional) Click Test to activate the screen saver test, which lasts 10 seconds then returns you to the Security window. 6. Click OK. Logging in to the console 1. Press any key or move the mouse. 2. The Password window opens. Type the password, then click OK. 3. The Main window opens if the password was entered correctly. Removing password protection from the console 1. From the Main window, click Setup - Security; the Password window opens. Type the password, then click OK. 2. In the Security window, click in the New field and press Enter or double-click in the New field. Leave the field blank. Press Enter. 3. Click in the Repeat field and press Enter or double-click in the Repeat field. Leave the field blank. Press Enter. 4. Click OK to eliminate the password. Enabling the screen saver mode with no password protection 1. If the console switch does not require a password to gain access to the Security window, proceed to step 2. -orIf the console switch is password protected, see the previous procedure, then go to step 2. 2. Select Enable Screen Saver. 3. Type the number of minutes for Inactivity Time (from 1 to 99) to delay activation of the screen saver. 4. Choose Energy if the monitor is ENERGY STAR compliant; otherwise select Screen. ATTENTION: Monitor damage can result from the use of Energy mode with monitors not compliant with ENERGY STAR.