IBM 62174DU Installation Guide - Page 33
Notes
UPC - 000435924971
View all IBM 62174DU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
RAID adapter installed, you can configure the internal hard disk drives into disk arrays. You can also cable a SCSI adapter to external hard disk drives. See your SCSI adapter option documentation for complete instructions for installing a SCSI adapter in your computer and for additional information about SCSI adapters. Notes: 1. The SCSI cables that are used by the integrated SCSI controller cannot be used with an optional SCSI adapter. 2. If you install a ServeRAID 6i+ adapter, it must be installed in slot 3; no cabling is required for this adapter. To cable an optional SCSI adapter, complete the following steps: 1. Install the SCSI adapter (see "Installing an adapter" on page 18). 2. Connect the SCSI-signal cable to the adapter and one or more of the signal cable connectors to the rear of the SCSI devices. 3. Connect the SCSI-activity-indicator cable to the adapter and to the SCSI-LED connector on the system board. See "System-board internal connectors" on page 14 for the location of the SCSI-LED connector. SCSI signal cable Rear adaptersupport bracket 1394 SCSI signal cable connector SCSI adapter SCSI LED Front adaptersupport bracket 4. Complete the installation of the optional SCSI adapter. Chapter 2. Installing the hardware 21