IBM 6656HG2 Service Manual - Page 13
Adjustment
UPC - 087944642084
View all IBM 6656HG2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ADJUSTMENT All adjustment are thoroughly checked and corrected when the monitor leaves the factory, but sometimes several minor adjustment may be required. Adjustment should be following procedure and after warming up for a minimum of 10 minutes. Alignment appliances and tools. - IBM Compatible PC - Programmable Signal Generator. (eg. VG-819 made by Astrodesign Co.) - E(E)PROM with each mode data saved. - Alignment Adapter and Software. 1. Adjustment for Factory Preset Mode 1) Run alignment program for LI561G on the IBM compatible PC. 2) Select EEPROM all clear command and Enter. 3) Display cross hatch pattern at Mode 1. 4) Select COMMAND PRESET START command. 5) Select FOS DEFAULT command and Enter. 6) Press "Y" key, it will automatically save all FOS data to EEPROM. 2. Adjustment for White Balance 1) Display color 0,0 pattern at Mode 13. 2) Set External Bright to MAX position and Contrast to MAX Position. 3) Select PRESET START → BIAS CAL command and Enter. 4) No attempt to manually adjust, BIAS data is automatically adjusted and saved to the EEPROM. 5) Display color 15,0 pattern at Mode 13. 6) Select DRIVE CAL command and Enter. 7) Color 2 (7200K) and Color 3 (9300K) are automatically adjusted and saved to the EEPROM. 8) Select PRESET EXIT command and Enter. 3. DDC Data Write Procedure 1) Use this procedure only when there is some probelm on EDID data. 2) Select EEPROM → EDID Write command and Enter. 3) This will write the EDID data to EEPROM. Control Line IBM Compatible PC 15 10 5 PARALLEL PORT Not used RS232C PARALLEL OFF ON 5V C F VGS A MONITOR B V-SYNC ST POWER Power inlet (required) 220 Power Select Switch (110V/220V) Power LED E ST Switch F V-Sync On/Off Switch (Switch must be ON.) A 9 11 5 6 1 6 1 13 25 C 1 14 ON E OFF 5V 4.7K 5V 4.7K 4.7K 74LS06 74LS06 B Figure 1. Cable Connection - 13 -