IBM 6792 User Guide - Page 48

To connect the first IDE CD drive or DVD drive, the new drive.

Get IBM 6792 - NetVista M41 - 256 MB RAM PDF manuals and user guides
UPC - 087944764670
View all IBM 6792 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 48 highlights

v If it is the first CD drive or DVD drive, set as a master device. v If it is an additional CD drive or DVD drive, set as a slave device. Refer to the documentation that comes with your drive for master/slave jumper information. 7. Install the drive into the bay. Align the screw holes and insert the two screws. 8. Pivot the drive bay cage back into place. 9. Each integrated drive electronics (IDE) drive requires two cables; a four-wire power cable that connects to the power supply and a signal cable that connects to the system board. 36 User Guide The steps to connect an IDE drive are different depending on the type of drive you are connecting. Locate the procedure below for your drive connection. To connect the first IDE CD drive or DVD drive 1. Locate the three-connector signal cable that came with your computer or with the new drive. 2. Locate the secondary IDE connector on the system board. See "Identifying parts on the system board" on page 30.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
v
If it is the first CD drive or DVD drive, set as a master device.
v
If it is an additional CD drive or DVD drive, set as a slave device.
Refer to the documentation that comes with your drive for master/slave
jumper information.
7.
Install the drive into the bay. Align the screw holes and insert the two screws.
8.
Pivot the drive bay cage back into place.
9.
Each integrated drive electronics (IDE) drive requires two cables; a four-wire
power cable that connects to the power supply and a signal cable that connects
to the system board.
The steps to connect an IDE drive are different depending on the type of drive you
are connecting. Locate the procedure below for your drive connection.
To connect the first IDE CD drive or DVD drive
1.
Locate the three-connector signal cable that came with your computer or with
the new drive.
2.
Locate the secondary IDE connector on the system board. See
“
Identifying parts
on the system board
”
on page 30.
36
User Guide