IBM 8676 Option Installation Guide - Page 26

the cable routing if you are installing the RAID adapter in PCI-X slot 2.

Get IBM 8676 - Eserver xSeries 335 PDF manuals and user guides
UPC - 087944770107
View all IBM 8676 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

the cable routing if you are installing the RAID adapter in PCI-X slot 2. RAID adapter SCSI cable SCSI backplane signal connector (J8) to hard disk drives Note: See the documentation that comes with the RAID adapter for any additional cabling instructions. That documentation also provides information about installing the RAID software and configuring the RAID adapter. v If you plan to install an optional IBM Remote Supervisor Adapter, install it in PCI-X slot 1. Use the ribbon cable that comes with the Remote Supervisor Adapter to connect the 20-pin connector on the rear edge of the adapter to the Remote Supervisor Adapter connector (J2) on the system board. For details about installing a Remote Supervisor Adapter, see the documentation that comes with the adapter. The following illustration shows the cable routing. Remote Supervisor Adapter Cable Remote Supervisor Adapter connector (J2) 14 IBM xSeries 335 Type 8676: Option Installation Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
the cable routing if you are installing the RAID adapter in PCI-X slot 2.
to hard disk drives
RAID adapter
SCSI cable
SCSI backplane
signal connector
(J8)
Note:
See the documentation that comes with the RAID adapter for any
additional cabling instructions. That documentation also provides
information about installing the RAID software and configuring the RAID
adapter.
v
If you plan to install an optional IBM Remote Supervisor Adapter, install it in
PCI-X slot 1. Use the ribbon cable that comes with the Remote Supervisor
Adapter to connect the 20-pin connector on the rear edge of the adapter to the
Remote Supervisor Adapter connector (J2) on the system board. For details
about installing a Remote Supervisor Adapter, see the documentation that comes
with the adapter. The following illustration shows the cable routing.
Remote Supervisor
Adapter connector
(J2)
Remote Supervisor
Adapter
Cable
14
IBM xSeries 335 Type 8676: Option Installation Guide