IBM 8677 Hardware Maintenance Manual - Page 46
Power modules, IBM BladeCenter E 2320 Watt Power, Modules Installation Guide
UPC - 000435842312
View all IBM 8677 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Power modules Note: The IBM BladeCenter E type 8677 and 1881 chassis must be configured to support 2320-watt power modules. See the IBM BladeCenter E 2320 Watt Power Modules Installation Guide for specific information and instructions. Your BladeCenter unit comes with one pair of 220-volt hot-swap power modules in power bays 1 and 2 that provides power to all the BladeCenter modules and to blade bays 1 through 6. The BladeCenter unit supports a second pair of power modules in power bays 3 and 4 that provides power to blade bays 7 through 14. Each pair of power modules is redundant. If either power module fails, the remaining power module continues to supply power, but there is no redundancy; the failed power module must be replaced as soon as possible. To provide true redundant power, BladeCenter power modules 1 and 3 must connect to a different ac power source than power modules 2 and 4. Connect BladeCenter power modules 1 and 3 to a different PDU than power modules 2 and 4; then, connect each PDU to an ac power source (building power source or service entrance) that is controlled by a separate circuit breaker. The following table summarizes the application for each power module Bays 1 and 2 3 and 4 Power module function Provides power to all the BladeCenter modules and to blade bays 1 through 6 Provides power to blade bays 7 through 14 Power modules are not needed in bays 3 and 4 until you begin installing blade servers and options in blade bays 7 through 14. Note: If you install a blade server that has a storage expansion unit option attached in blade bay 6, the option will use blade bay 7; power modules will be required in power bays 1, 2, 3 and 4. Each active power module supplies 12 volts of power to the blade bays it services. Important: Plug one end of each power-module power cord into the power module; plug the other end of the power cord into a 220-volt power distribution unit (PDU). Blower modules Your BladeCenter unit comes with two hot-swap blowers for cooling redundancy. The blower speeds vary depending on the ambient air temperature at the front of the BladeCenter. If the ambient temperature is 72°F or below, the BladeCenter blowers will run at 30% of their maximum rotational speed, increasing their speed as required to control internal BladeCenter temperature. If the ambient temperature is above 72°F, the blowers will run at 80% of their maximum rotational speed, increasing their speed as required to control internal BladeCenter temperature. If a blower fails, the remaining blower continues to cool the BladeCenter unit and blade servers. Important: Replace a failed blower as soon as possible, to restore cooling redundancy. 36 BladeCenter E Type 8677 and 1881: Hardware Maintenance Manual and Troubleshooting Guide