IBM DPSS-309170 Installation Manual - Page 19
My Computer, Control Panel, Add/Remove Programs, Startup Disk tab, Create Disk, FORMAT A:/S, ENTER
View all IBM DPSS-309170 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
IBM storage products Appendix A. How to create a bootable diskette If you have a bootable Windows operating system, follow the steps below to create a Windows 95 or 98 startup diskette: 1. Insert a blank floppy disk into drive A. 2. From Windows 95 or 98, double click My Computer. 3. Double click Control Panel. 4. Double click Add/Remove Programs. 5. Select Startup Disk tab. 6. Click Create Disk. Follow the prompts. If you have a bootable DOS operating system, follow the steps below to create a DOS startup diskette: 1. Insert a blank floppy disk into drive A. 2. At the C:\ prompt, type FORMAT A:/S and press ENTER. 3. Follow the instructions displayed. B. Controller information The examples in this guide use an Adaptec controller. If a chip set is embedded into your motherboard, plug the cable into the port on the motherboard instead of the controller. If you are purchasing an add-on controller card, you will need to install the controller in one of the empty slots in your computer. Remove the screw holding the metal plate in place and insert the controller into the appropriate PCI, EISA or ISA slot on the motherboard, making sure the metal plate from the controller fits into the grooves on the computer frame. Replace the screw and connect the SCSI cables to the controller and then the hard drive. If you have any questions, refer to the installation manual enclosed with your controller. IBM Technology Group Support Center Page 19 07N5612IG10