IC Realtime IPMX-E40F-IRW1-AI Product Manual - Page 5
Higure 3-5, esktop Ìtility ´pps, Higure 3-1
View all IC Realtime IPMX-E40F-IRW1-AI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
2C. RESTORE FACTORY DEFAULTS Important: Please use RESET button when device is running. Step 1 Please refer to Step 1 and Step 2 in Section 2A to loosen the dome body. Push a little bit; you can take the dome body from the gland cover. Step 2 Take the dome body out and then turn the top cover hard to remove. Step 3 Slightly press the RESET button for 15-30 seconds to complete the factory reset. The camera will reboot. See Figure 3-5. 3A. OVERVIEW The IP Config tool is used to search the local network for IC Realtime devices as well as modify the IP addresses and upgrading firmware. This software can be downloaded at: https://icrealtime.com/downloads under Desktop Utility Apps 3B. OPERATION Double click the "ConfigTools.exe" icon to run. The interface will be displayed as shown in Figure 3-1. Click on the blue circle icon with the two arrows to refresh and scan the network. Figure 3-5 Step 4 Turn the top cover back to the original position. Please make sure it reaches the original position, otherwise it may result in water leakage! Step 5 Put the dome back to the compression cover. Please refer to Step 4 in Section 2A to install the decoration ring back. 5 | www.icrealtime.com Figure 3-1