Icom A25 Navigation Guide - A25n - Page 1

NAVIGATION GUIDE VHF AIR BAND TRANSCEIVERS Iç-A25N Iç-A25NE Thank you for choosing this Icom product. READ ALL INSTRUCTIONS carefully and completely before using this product. Bluetooth® OPERATION DDOperating Bluetooth® The IC-A25N and IC-A25NE have a built-in Bluetooth unit. You can connect Bluetooth headsets, or other Bluetooth devices to use some of navigation functions. The communication range of Bluetooth is approximately 10 meters (33 ft). DDPairing with a device You can pair Bluetooth headsets and data devices to the transceiver, as shown below: ••A maximum of 5 Bluetooth headsets and data devices. ••A maximum of 2 Low Energy (LE) devices. LThese instructions describe pairing with the VS-3 Bluetooth® headset, as an example. Bluetooth® IC-A25N or IC-A25NE Bluetooth headset (Example: Optional VS-3 ) 1. Turning ON the transceiver's Bluetooth function 1. Push [MENU]. 2. Select "Bluetooth Set," and then push [ENT]. (Bluetooth > Settings > Bluetooth Set) 3. Select "ON," and then push [ENT]. 4. Push [MENU] to return to the Main screen. 2. Entering the VS-3 Pairing mode Refer to the VS-3's instruction manual for details. NOTE: ••The Bluetooth communication range may vary, depending on the environment where you operate the device. ••The key beep sound may distorts when using the transceiver with a Bluetooth headset. Reduce the key beep level to prevent the distortion. ([MENU] > Sounds Settings > Beep) ••You cannot switch the optional VS-3 Bluetooth headset to other devices, if the VOX level is set to 6. ([MENU] > Radio Settings > VOX Level) DDElectromagnetic Interference When you use a Bluetooth device, pay attention to the following: Bluetooth devices operate in the 2.4 GHz band. The 2.4 GHz band is also used by other devices, such as Wireless LAN products, microwave ovens, RFID systems, amateur radio stations, and so on. When using this device near such devices, interference may occur, causing a decrease in communication speed, and an unstable connection. In such cases, use this device away from the other devices, or stop using those devices. 3. Pairing and connecting the Bluetooth headset 1. Push [MENU]. 2. Select "Search Device," and then push [ENT]. (Bluetooth > Pairing/Connect > Search Device) LThe transceiver cannot search for a new headset or device if it is connected with more than 2 headsets or devices. 3. Select "Headset." ••The transceiver searches for a headset. LPush [CLR] to cancel searching. 4. Select the headset to pair, and then push [ENT]. L"No Device Found" is displayed if no headsets or devices are found. LA passkey or PIN code may be required to pair, depending on the headset or device. Refer to your headset or device's instructions for details. LThe headset or device name changes to its Bluetooth device address in 5 seconds. 5. Push [MENU] to return to the Main screen is displayed if the headset or device is correctly connected. - 1 -