Icom IC-705 Advanced Manual english - Page 223
Troubleshooting for the Terminal mode operation
View all Icom IC-705 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 223 highlights
15. ABOUT THE DV GATEWAY FUNCTION Troubleshooting DDTroubleshooting for the Terminal mode operation The following chart is designed to help you correct problems which are not equipment malfunctions. If you are unable to locate the cause of a problem or solve it through the use of this chart, contact your Icom Dealer or Service Center. Problem Possible Cause Solution REF. After your call, the repeater Transceiver connection is wrong. does not return a status reply. When using the Internal Gateway function, check the connection between the transceiver and the router. p. 15-11 When using the External Gateway pp. 15-13, function, check the connection 15-14 between the transceiver and the Windows or the Android device. "Allowed Call Sign" is set to "Enable." When using the Internal Gateway function, set "Allowed Call Sign" to "Disable" in the INTERNAL GATEWAY SETTINGS screen. p. 15-11 When using the External Gateway RS-MS3W, function, set "Allowed Call sign" RS-MS3A's to "Disable" in the RS-MS3W or RS-MS3A. instruction manual When using the External Gateway function, you did not click (touch) in the RS-MS3W or RS-MS3A. Click (touch) in the RS-MS3W or RS-MS3A. After your call, the repeater The call was successfully sent, but Wait for a while, and try again. - replies "UR?," Your own call no station immediately replied. sign (MY) and ID suffix "G." After your call, the repeater replies "RX" or "RPT?" and Your own call sign (MY) and ID suffix "G." Your call sign (MY) has not been registered at a gateway server. Register your call sign (MY) at a - gateway server. The Terminal/AP call sign that is When using the Internal Gateway p. 13-5 set in the transceiver, RS-MS3A, or function, register the Terminal/ RS-MS3W has not been registered AP call sign that is set in the in the RS-RP3C as the access transceiver in the RS-RP3C as the point. access point. When using the External Gateway p. 13-5 function, register the Terminal/ AP call sign that is set in the RS-MS3A or RS-MS3W in the RSRP3C as the access point. The destination station's call sign Check the destination station's - (UR) has not been registered to the register information. gateway server, or the registered contents do not match your transceiver's setting. The destination station that uses The destination station makes a - the Terminal mode or Access Point call again. mode does not transmit periodically. 15-23