Icom IC-F5011 / IC-F6011 Instruction Manual - Page 11

BASIC OPERATION, ■ Turning ON the power, ■ Channel selection

Get Icom IC-F5011 / IC-F6011 PDF manuals and user guides View all Icom IC-F5011 / IC-F6011 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

2 BASIC OPERATION ■ Turning ON the power ■ Channel selection 1 q Push [ ] to turn ON the power. There are several methods to select channels, and they may 2 w If the transceiver is programmed for a start up password, differ, according to your system set up. 3 input the digit codes as directed by your dealer. • The keys shown below can be used for password input: Push [CH Up] or [CH Down] to sequentially select the desired 4 The transceiver detects numbers in the same block as identical. Therefore "01234" and "56789" are the same. operating channel, or push one of the [MR-CH 1] to [MR-CH 4] keys to select a channel directly. 5 6 KEY P0 P1 P2 P3 AUTOMATIC SCAN TYPE: Channel setting is not necessary for this type. When turn- 7 NUMBER 0 1 2 3 4 56789 ing ON power, the transceiver automatically starts scanning. 8 Scanning stops when a signal is detected. 9 10 e If all channel indicator LEDs still blink after inputting 4 digits, the input code number may be incorrect. Turn OFF the 11 power and re-enter your password. 12 13 14 15 16 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
7
2
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
■
Turning ON the power
q
Push
[
]
to turn ON the power.
w
If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
• The keys shown below can be used for password input:
The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
e
If all channel indicator LEDs still blink after inputting 4 dig-
its, the input code number may be incorrect. Turn OFF the
power and re-enter your password.
■
Channel selection
There are several methods to select channels, and they may
differ, according to your system set up.
Push [CH Up] or [CH Down] to sequentially select the desired
operating channel, or push one of the [MR-CH 1] to [MR-CH 4]
keys to select a channel directly.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turn-
ing ON power, the transceiver automatically starts scanning.
Scanning stops when a signal is detected.
KEY
NUMBER
0
5
4
9
3
8
2
7
1
6
P0
P1
P2
P3