Icom IC-F9011 Instruction Manual 1 - Page 17
BASIC OPERATION, Turning power ON, Channel selection
View all Icom IC-F9011 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
3 BASIC OPERATION ■■Turning power ON ■■Channel selection 1 • Prior to using the transceiver for the first time, the battery Several types of channel selections are available. Methods 2 pack must be fully charged for optimum life and opera- may differ according to your system set up. 3 tion. (p. 17) • When you use the transceiver for the first time, or after the transceiver has sat unused for a long time, make sure to check the date and time indication after turning NOTE: Depending on the pre-setting, "EMPTY" appears 4 on the LCD when selecting an empty channel (no fre- quency is programmed). (Simple/10-key types only) 5 the power ON. If the time and date are not correct, reset NON-ZONE TYPE: 6 them. (p. 15) To select the desired operating channel: 7 q Rotate [VOL] to turn the power ON. w If the transceiver is programmed for a start up password, input the digit codes as directed by your dealer. • 10-keypad can be used for password input depending on ver- sion. • Push [CH Up] or [CH Down]. • Rotate [ROTARY SELECTOR]*. - Up to pre-programmed 16 channels can be selected. • Push one of [MR-CH 1] to [MR-CH 4]. ZONE TYPE: 8 9 10 • The keys in the table below can be used for password input. To select the desired zone: 11 • The transceiver detects numbers in the same block as identical. Therefore "01234" and "56789" are the same. • Push [Zone], then push [CH Up] or [CH Down]. • Rotate [ROTARY SELECTOR]*. 12 KEY - Up to pre-programmed 16 zones can be selected. 13 NUMBER 0 1 2 3 4 5 6 7 8 9 AUTOMATIC SCAN TYPE: Channel setting is not necessary for this type. When turn- 14 ing power ON, the transceiver automatically starts scanning. 15 e When the "PASSWORD" indication does not clear after in- Scanning stops when receiving a call. 16 putting 6 digits, the input code number may be incorrect. Turn the power OFF and start over in this case. When you operate Non-display type, the password setting is not available. * Depending on the pre-setting. When [Rotary selector] selects "Operating channel," [CH Up]/[CH Down] are not available, and when [Rotary selector] selects "Operating zone," [Zone]/[Zone Up]/ [Zone Down] are not available. 12