Icom IC-U86 Advanced Manual - Page 22
Programming channel names, Setting the display type, Selectable characters
View all Icom IC-U86 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
5 MEMORY/CALL OPERATION Programming channel names Each memory channel and the Call channel can be programmed with an alphanumeric channel name, for easy recognition. Names can be a maximum of 5 characters. DDSetting the display type 1. Hold down [ ] for 1 second to turn OFF the transceiver. 2. While holding down [Y] and [Z], turn ON the power to enter the Initial Set mode. 3. Push [Y]/[Z] to select the display type item. (dSP) 4. Rotate [VOL] to select "dSP.nm." 5. Push [# ENT] to exit the Initial Set mode. DDProgramming a channel name 1. Select the channel name display in the Initial Set mode. (See the above topic.) 2. Push [VFO/MR/CALL] several times to select the memory mode or Call channel mode. •• For memory channel: Push [Y] or [Z] to select the desired memory channel. 3. P ush [FUNC], and then push [SET] to enter the channel name programming mode. •• A cursor blinks for the first character. 4. Rotate [VOL] to select a character. •• The selected character blinks. 5. Push [Y] to move the cursor right, push [Z] to move the cursor left. 6. Repeat steps 4 and 5, until the desired channel name is completed. 7. Push [# ENT] to exit the programming mode. The "Display type" item in the Initial Set mode ("Name" is selected) Example: Programming "CALL" into memory channel 12. Push or to select channel 12. (Memory mode) Push , and then push . Rotate [VOL] to select the character, and then push or to move the cursor. Push Repeat until the name is complete. to exit the programming mode. DDSelectable characters (A) (b) (C) (d) (E) (F) (G) (H) ( I ) (J) (k) (L) (m) (n) (O) (P) (q) (R) (S) (t) (U) (V) (W) (X) (y) (Z) (1) (2) (3) (4) (5) (6) (7) (8) (9) (0 Space) 5-6