Icom IP100H Instruction Manual ver.2.20 - Page 37

7 FOR YOUR REFERENCE Troubleshooting The following chart is designed to help you correct problems which are not equipment malfunctions. If you are unable to locate the cause of a problem, or solve it through the use of this chart, contact your nearest Icom Dealer or Service Center. PROBLEM POSSIBLE CAUSE SOLUTION REF. No power comes ON. ••The battery charge is exhausted. ••T he connection of the battery pack or battery case is bad. ••Charge the battery pack, or replace the batteries. ••Remove, clean, and reattach the battery pack or battery case terminals. pp. 2-4 2-8 - No sound comes from the ••Volume level is too low. speaker. ••Rotate [PWR/VOL] to adjust to a desired p. 3-2 level. No reply is received ••Too far from an access point. ••Move your location, then try again. - ••The " " icon blinks. ••The operator is away from the terminal, or ••Wait until the operator is back, or ask - the terminal is turned OFF. system manager about the status. "Key lock" is displayed when a key is pushed ••The Key Lock function is turned ON. ••Hold down [CLR• ] for 1 second to turn the Key Lock function OFF. p. 3-3 Cannot charge the battery pack completely (except for the BC-202IP2 and BC-202IP3L) ••The communication terminal power is ON. ••Turn OFF the power. pp. 2-4 2-6 The charging indicator blinks orange, or alternately blinks orange and green ••The battery pack is not properly inserted. ••Insert the battery pack properly. ••Charging the battery pack outside of the ••Charge the battery pack in the chargeable temperature range. chargeable temperature range: BC-202: 0°C to 40°C (32°F to 104°F) BC-202IP2/BC-202IP3L BC-211: 10°C to 40°C (50°F to 104°F) ••The connection of the charging terminals ••Remove, clean, and reattach the charger is bad. terminals. ••T he communication terminal power is ON. ••Turn OFF the power. (except for the BC-202IP2 and BC-202IP3L) pp. 2-4 2-6 p. 2-3 - - pp. 2-4 2-6 The " " icon blinks, or ••SSID Broadcast function is OFF in an ••Ask your system manager about the - "Connecting..." is displayed access point (when 5 GHz band is used). access point settings. (standby screen won't be ••Too far from an access point. ••Move your location, then try again. - displayed) ••Access point power is OFF. ••Turn ON the access point power. - 7-2