Image Fitness 760 Treadmill English Manual - Page 6

ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials except for the packing materials around the brackets on the uprights (see step 1). Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. Assembly requires the included allen wrenches and your own phillips screwdriver and wire cutters . Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled. 3/4" Screw (108)-10 1" Tek Screw (80)-2 1/4" Washer (39)-4 1/4" Silver Star Washer (77)-4 5/16" Star Washer (36)-4 Silver Ground Screw (103)-1 Extension Leg Bolt (96)-4 2 1/2" Bolt (61)-4 4" Bolt (76)-4 1. Make sure that the power cord is unplugged. With the help of another person, carefully tip the treadmill onto its left side. Partially fold the Frame (59) so the treadmill is more stable. Do not fully fold the treadmill until it is completely assembled. Identify the Left Upright (29) and the Right Upright (30); the indicated brackets on the Uprights overhang toward the center of the treadmill. Make sure there are two UNuts (122) (see the inset drawing) in the lower end of each Upright. Feed the Wire Harness (74) into the bottom of the Right Upright, and pull the Wire Harness out of the hole in the top of the Right Upright. Note: There may be a tie on the Wire Harness to help you pull it out of the hole. Attach the Right Upright (30) to the right side of the Base (97) with two 2 1/2" Bolts (61) and two 5/16" Star Washers (36). Do not tighten the Bolts yet. Be careful not to damage the Wire Harness (74). Attach the Left Upright (29) to the left side of the Base in the same way. Note: There is not a wire on the left side. 1 74 30 Brackets 29 59 1a 29, 30 122 6 97 36 61 36 61