Image Fitness Renew 631 Spa User Manual - Page 12
Using the Controls
View all Image Fitness Renew 631 Spa manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Using the Controls Air Controls 1, 2, and 3 Display Invert Button Display Pump 1 Pump 2 Light Temperature Button Button Button Buttons AB A C A B Air Control 1: Determines the amount of air flowing through the hydrotherapy jets labeled A (above). If the control is turned counterclockwise, the amount of air flowing through the jets will increase; if the control is turned clockwise, the amount of air will decrease. Air Control 2: Determines the amount of air flowing through the hydrotherapy jets labeled B (above). If the control is turned counterclockwise, the amount of air flowing through the jets will increase; if the control is turned clockwise, the amount of air will decrease. Air Control 3: Determines the amount of air flowing through the hydrotherapy jet labeled C (above). If the control is turned counterclockwise, the amount of air flowing through the jet will increase; if the control is turned clockwise, the amount of air will decrease. Display Invert Button: Turns the display 180°, allowing it to be read from inside or outside of the spa. Pump 1 Button: Turns the spa jets labeled B and C (at the left) on and off. If the button is pressed once, the jets will run, providing gentle hydrotherapy. If the button is pressed again, the jets will shut off. Pump 2 Button: Turns the spa jets labeled A (at the left) on and off. If the button is pressed once, the jets will run, providing soothing hydrotherapy. If the button is pressed again, the jets will shut off. The spa also features an automatic mode that heats and filters the water when the spa is left unattended. When the power to the spa is first turned on, or if the water temperature is below the set temperature, the water will be heated as required to maintain the set temperature. Note: To keep the filter and heat cycles from running, the power to the spa must be turned off. Light Button: Turns the underwater light on and off. Temperature Buttons: Control the temperature setting of the water. The temperature setting can be from 80°F to 104°F. The water heats at about 6°F per hour with the cover on. Use a medical or other accurate thermometer to check the temperature of the water. Note: The word "COOL" will appear in the console display if the temperature of the water is more than 20°F cooler than the set temperature. When this happens, the heater will automatically activate to warm the water. The word "ICE" will appear in the display if the temperature drops below 40°F. If this happens, the pump will automatically circulate the water and warm the plumbing to keep the water from freezing. 12