InSinkErator Model Hot1 Owners Manual - Page 8

4 CONNECTING WATER TO DISPENSER A I Bend and position the 1/4" copper line from the dispenser so it fits into the cold water supply. With one hand, support the copper line coming out of the tank and bend the tube with the other hand. I Do not kink. Bend tube carefully. Property Damage: Make sure the bends in tubing are smooth and not kinked. Don't use paste-type sealants on water line connections. Tighten compression fittings snug but don't over tighten. B Nut Ferrule I When connecting to a compression type T-fitting or valve, remove the nut and ferrule (round brass piece) from the fitting. Then, place the nut followed by the ferrule over the end of the tube coming from the dispenser. C I Push the tube end all the way into the T-fitting or valve. Hold the tube end in position and push the ferrule down as far as it will go. Then, tighten the nut over the ferrule with your fingers. Make sure the tube end is going straight into the hole. Then tighten the nut firmly with a 1/2" wrench. 8