Insignia IS-TV040921 User Manual (English) - Page 10

PREPARATION FOR USE ANTENNA/CABLE CONNECTION Cables used here are commercially available. [ANTENNA CONNECTION] [CATV/SATELLITE CONNECTION] 75-ohm Coaxial Cable VHF/UHF VHF/UHF OR VHF Combiner CATV Box or Satellite Box * OUT IN UHF Flat twin- OR lead cable VVHHFF Adaptor oorr UUHHFF COAXIAL ANT. ANT. From Cable System or Satellite Antenna 75-ohm OR Coaxial Cable From Cable System *Some cable TV systems use scrambled signals and require a special converter to receive these channels. Consult your local cable company. Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical. NOTE: • Before plugging the antenna into the ANT. jack of the unit, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into the ANT. jack of the unit. Bent pin Cable Plug (Needs to be straightened) (Straight pin) VHF/UHF COMBINED ANTENNA A VHF UHF 75 ohm combination antenna can be connected to ANT. jack of the unit. VHF/UHF SEPARATE ANTENNAS In some areas it will be necessary to use an outdoor antenna. CABLE WITHOUT CONVERTER/ DESCRAMBLER BOX Use this connection if your cable system connects directly to the unit without a converter box. CABLE WITH CONVERTER/DESCRAMBLER BOX OR SATELLITE BOX If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown above. Channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the remote control of this unit. NOTE: • For your safety and to avoid damages to the unit, unplug the antenna cable from the ANT. jack before moving the unit. - 10 - EN