Insignia NS-A1112 User Manual (English) - Page 5

Insignia NS-A1112 Executive Shelf System with Tuner Number 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 Control Standby button Numeric keypad +10 button Volume - button Stop button Skip - / Tuning button CD Play / Pause button Program button Mode button Backlight button EQ button Volume + button Skip + / Tuning + button Mute button Tuner / Band button AUX button Preset + / - button Setting up your executive shelf system Unpacking the executive shelf system How to unpack the executive shelf system: 1 Carefully unpack the stereo and speakers, then remove all packing material from around the stereo. 2 Position the stereo horizontally on a heavy-duty stand or firm, level surface away from the speaker system to avoid acoustic feedback. Connecting the executive shelf system How to connect the executive shelf system: 1 Connect the wires from the speaker box to the speaker connections on the back of the stereo. 2 Connect the AC power cord to an AC outlet. NOTE: Before operating the stereo in a new area for the first time, you must check that the operating voltage of your stereo is identical to the voltage of your local power supply. This stereo is to be operated only at the power source voltage printed on the back panel. Disconnect from the power outlet when not in use for a long period of time. Preparing the remote control Installing remote control batteries Warning Do not throw the batteries into fire. Dispose of used batteries as hazardous waste. Caution Do not drop or disassemble the remote control. Do not get the remote control wet. To install batteries in the remote control: 1 Remove the battery cover. 2 Insert two AAA batteries into the battery compartment. Make sure that the +/- symbols on the battery match the +/- marks inside the battery compartment. 3 Replace the battery cover. Note When the remote control will not be used for a long period of time or when the batteries are worn out, remove the batteries to prevent leakage. Using the executive shelf system Turning the stereo off and on There are several ways to turn on the executive shelf system: 1 Press Standby/On once to turn on the stereo and light the backlight. Note: When the power is off, pressing Backlight on the remote control will turn the backlight on or off. After turning off the stereo, the backlight will be off. 2 Press Play/Pause once to turn on the stereo, which will read the TOC and start playback automatically. 3 Press Tuner/Band once to turn on the stereo and restore the band and frequency playing when the stereo was turned off. 4 Press AUX once to turn on the stereo and select AUX input. Using the remote control To change modes for the executive shelf system: 1 Press Standby/On on the remote control to turn the power on. 2 After the remote control is turned on, press • Press Tuner/Band to select the tuner. • Press CD Play/Pause to select the CD. • Press AUX to select an auxiliary source component. NOTE: When using the remote control and you are required to move closer to the stereo for the remote control to operate, replace both batteries. The remote control may not operate correctly if direct sunlight or the light of a high-frequency fluorescent lamp enters the remote control light sensor. In this case, change the system installation position to prevent the problem. www.insignia-products.com 5