Insignia NS-AF10DSS2 User Guide - Page 5
Overheating Protection, Plasticizer warning, Automatic switch-off, Extension cord instructions,
View all Insignia NS-AF10DSS2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
10 Qt. Air Fryer Oven • Let the appliance cool down for approximately 30 minutes before you handle or clean it. • The air fryer oven may smoke the first time it is used. It is not defective and the smoke will burn off within a few minutes. Overheating Protection The appliance comes with an overheating protection system. It will be turned off automatically if the inner temperature control system fails. If that happens, unplug the power cord, let the appliance cool down, and send it to authorized service center for repair. Plasticizer warning CAUTION: To prevent plasticizers from migrating to the finish of the counter top or table top or other furniture, place NON-PLASTIC coasters or place mats between the appliance and the finish of the counter top or table top. Failure to do so may cause the finish to darken. Permanent blemishes may occur or stains can appear. Automatic switch-off The appliance comes with a built-in shut-off device that automatically shuts down the unit when it reaches the preset time. You can manually switch off the appliance at any time by pressing the Power Button. The fan will continue running for about 20 seconds to cool down the unit. Extension cord instructions • An extension cord may be used if the following care is exercised in their use: • The marked electrical rating of the extension cord should be at least as great as the electrical rating of the appliance (860 W). • A longer cord should be arranged so that it will not drape over the counter or table top where it could be pulled on by children or tripped over unintentionally. About the power cord Your air fryer oven has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way. If the power cord is damaged, it must be replaced by the manufacturer, its service agent, or a similar qualified person, in order to avoid hazard. SAVE THESE INSTRUCTIONS www.insigniaproducts.com 5