Insignia NS-FLWDPW3 User Guide - Page 10
STEP 5: Leveling the washer or dryer
View all Insignia NS-FLWDPW3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
STEP 5: Leveling the washer or dryer You need: OR 8 mm socket wrench NS-FLWDPW3 WITH 8 mm socket Electric screwdriver Phillips screwdriver 17 mm open end wrench or adjustable wrench 1 Stand the washer or dryer upright, then move it close to its final location. 2 If the washer or dryer is not level, use an open ended wrench to adjust the legs up or down. 3 Tighten each lock nut against the bottom of your pedestal. Note: To minimize vibration: • The locking nuts must be tight. • Make sure that all four rubber leveling legs are firmly touching the floor. Push and pull on the back right and then the back left of your washer or dryer to make sure the legs are even. 10 www.insigniaproducts.com
10
NS-FLWDPW3
www.insigniaproducts.com
STEP 5: Leveling the washer or dryer
You need:
1
Stand the washer or dryer upright, then move it close to its final location.
2
If the washer or dryer is not level, use an open ended wrench to adjust the legs
up or down.
3
Tighten each lock nut against the bottom of your pedestal.
Note
: To minimize vibration:
•
The locking nuts must be tight.
•
Make sure that all four rubber leveling legs are firmly touching the floor. Push
and pull on the back right and then the back left of your washer or dryer to
make sure the legs are even.
8 mm socket wrench
Phillips screwdriver
17 mm open end wrench or
adjustable wrench
OR
WITH
Electric screwdriver
8 mm socket