Insignia NS-FWM27W1 User guide - Page 46

USER MAINTENANCE INSTRUCTIONS Storing your washer You can damage your washer if you don't remove water from hoses and internal components before storage. To prepare your washer for storage: 1 Select the Quick Wash cycle and add bleach to your washer. Run your washer through the cycle without a load. 2 Turn the water faucets off and disconnect the inlet hoses. 3 Unplug your washer from the electrical outlet and leave your washer's door open to let air circulate inside the tub. CAUTION: If your washer has been stored in below-freezing temperatures, allow time for any leftover water in your washer to thaw out before use. Troubleshooting CAUTION: Don't try to repair your washer yourself. Doing so invalidates the warranty. PROBLEM SOLUTION Washer doesn't start Door is locked or doesn't open The water isn't hot. • Make sure that your washer is plugged in. • Make sure that the door is closed. • Make sure that the water source faucets are open. • Make sure that you press the Power button to start your washer. • Make sure that you press the Start/Pause button. • Make sure that the Child Lock isn't turned on. See Setting the child lock on page 34. • Make sure that the Delay option isn't turned on. See Step 6: (Optional) Set a delayed start time on page 32. • Check the fuse or reset the circuit breaker. • You can't open the door if your washer is running. Press the Start/Pause button for three seconds. When the washer drum has stopped, open the door and add clothing. Close the door, then press the Start/Pause button again to restart the load. Note: Don't use the pause function when the water surface is over the edge of the inner tub or when the temperature is too hot. • If the door is locked when your washer isn't running, unplug the power cord, then plug it back in. • Check the status of your hot water heater, you may be out of hot water. • Note: You can still wash clothes in cold water only. 46 www.insigniaproducts.com