Insignia NS-HWMC1848 User Guide - Page 21

Step 4, Option 1 - Mount the frame to a stud wall, You'll need

Get Insignia NS-HWMC1848 PDF manuals and user guides View all Insignia NS-HWMC1848 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

3-in-1 TV STAND Step 4: Option 1 - Mount the frame to a stud wall NOTE: See Step 4: Option 2 for instructions on mounting the frame to a concrete wall. 1 Use a stud sensor to locate two adjacent wall studs, then position the mounting frame (N) exactly between the two studs. 2 Use a level to make sure that the mounting frame is level, then mark the four mounting holes. Remove the mounting frame. 3 Drill four 3/16" (4.76 mm) holes 2.5" (64 mm) deep. 4 Align the mounting frame (N) with the pilot holes, then secure it to the wall with four lag bolts (AA) and four washers (BB). CAUTION: Make sure that the lag bolts are tight and secure, but do not overtighten them. 0.19" (4.76 mm) BB AA BB AA 2.50" (64 mm) You'll need: AA (4) BB (4) Level Edge-to-edge stud finder 3/16" drill bit Pencil 1/2" Socket wrench Drill www.insigniaproducts.com 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
21
3-in-1 TV STAND
www.insigniaproducts.com
Step 4
:
Option 1 - Mount the frame to a stud wall
NOTE
: See Step 4: Option 2 for instructions on mounting the frame to a concrete wall.
1
Use a stud sensor to locate two adjacent wall studs, then position the mounting frame (
N
) exactly between the
two studs.
2
Use a level to make sure that the mounting frame is level, then mark the four mounting holes. Remove the
mounting frame.
3
Drill four 3/16" (4.76 mm) holes 2.5" (64 mm) deep.
4
Align the mounting frame (
N
) with the pilot holes, then secure it to the wall with four lag bolts (
AA
) and four
washers (
BB
).
CAUTION
: Make sure that the lag bolts are tight and secure, but do not overtighten them.
AA
AA
BB
BB
2.50”
(64 mm)
0.19”
(4.76 mm)
You’ll need:
AA
(4)
BB
(4)
Level
Edge-to-edge
stud finder
Pencil
3/16” drill bit
Drill
1/2” Socket wrench