Insignia NS-TDRG67W1 User guide - Page 23

INSTALLATION INSTRUCTIONS Bottom venting TOP VIEW 12-Cycle Electric and Gas Dryers SIDE VIEW 4.5 in. (11.4 cm) 12.1 in. (30.8 cm) 1.5 in. (3.8 cm) 3.5 in. (9.3 cm) 1 Remove the two rear exhaust retaining screws, then pull out the exhaust duct. Retaining screw Rear exhaust duct 2 Press the tabs on the knockout, then carefully remove the knockout for the desired vent opening. 3 Push the adapter duct onto the blower housing of the dryer.  Adapter duct Knockout DRYER SIDE/BACK VIEW 4 Connect a 4 in. (10.2 cm) elbow to the 4 in. (10.2cm) duct section, and secure all joints with aluminum tape. Make sure that the male end of the elbow faces down through the hole in the bottom from the dryer. 5 Insert the elbow/duct assembly through the rear opening and press it onto the adapter duct. Secure in place with aluminum tape. The male end of the duct should protrude 1.5 in. (3.8 cm) out of the dryer to connect the remaining ductwork. www.insigniaproducts.com 23