Insignia NSRSW211 User Manual (English) - Page 14

Rocketboost™ Wireless Subwoofer • 1 stereo HD quality + 3 CD quality -or• 2 stereo HD quality + 2 stereo CD quality -or• 3 stereo HD quality Note HD streams are available if using the wireless sender from the RF-RBKIT (Wireless HD Audio Starter Kit). If your system is in a maximum audio stream state, then the Send mode indicator will not light on the wireless sender devices that have exceeded the maximum. To use those device's audio streams, turn off one of your other wireless senders. Maintaining your system Use a soft cloth dampened with a weak solution of mild detergent and water. Dry the device immediately afterwards with a clean cloth. Do not use abrasive cloth, thinners, alcohol, or other chemical solvents, because they may damage the finish or remove the panel lettering. Cautions • Do not block the ventilation openings. • If the power cord is damaged, it must be repaired by a qualified technician. Troubleshooting Check this information for a possible solution before calling for assistance. General troubleshooting • Every Rocketboost network must contain only one hub device, which helps other Rocketboost devices join the network. • The wireless subwoofer must be wirelessly connected or joined to the Rocketboost hub device (see "Connecting your subwoofer for wireless mode" on page 11). • You can turn any Rocketboost wireless sender or wireless sender/receiver into a hub by using the HUB STATUS or HUB ENABLE switch on the back of the device. The network can only have one hub. • The hub device must have power for the audio network to operate. The hub can be in standby (power-saving mode), but must remain plugged in. • The existing hub device is the device with the green power indicator. • The unobstructed operating range of a Rocketboost network is 150 feet (45 meters). 14 www.insigniaproducts.com