Intel DG33BU Product Guide - Page 63
A Error Messages and Indicators, BIOS Beep Codes, BIOS Error Messages - problem
UPC - 735858192095
View all Intel DG33BU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
A Error Messages and Indicators Desktop Board DG33BU reports POST errors in two ways: • By sounding a beep code • By displaying an error message on the monitor BIOS Beep Codes The BIOS also issues a beep code (one long tone followed by two short tones) during POST if the video configuration fails (a faulty video card or no card installed) or if an external ROM module does not properly checksum to zero. Table 12 lists the BIOS codes. Table 12. Beep Codes Beep 3 Siren Description No memory Processor overheat (on reboot) BIOS Error Messages When a recoverable error occurs during the POST, the BIOS displays an error message describing the problem. Table 13 gives an explanation of the BIOS error messages. Table 13. BIOS Error Messages Error Message PROCESSOR_THERMAL_TRIP_ERROR MULTI_BIT_ECC_ERROR SINGLE_BIT_ECC_ERROR CMOS_BATTERY_ERROR CMOS_CHECKSUM_ERROR CMOS_TIMER_ERROR MEMORY_SIZE_DECREASE_ERROR INTRUDER_DETECTION_ERROR SPD_TOLER_ERROR MEM_OPTIMAL_ERROR Explanation Processor was previously shutdown due to a thermal event (overheating). The firmware has detected that a Multi-Bit ECC Error occurred. The firmware has detected that a Single-Bit ECC Error occurred. The firmware has detected that a CMOS battery failure occurred. The firmware has detected that a CMOS Checksum Error occurred. The firmware has detected that the system date/time has not been set. The firmware has detected that the system memory has decreased. The system chassis was opened. SERIAL PRESENCE DETECT (SPD) device data missing or inconclusive. Properly programmed SPD device data is required for reliable operation. The installed amount of memory in Channel A is not equal to the amount of memory in Channel B. Maximum memory performance is achieved with equal amounts of memory installed in each channel. 63