Intel DP43BF Product Guide - Page 19

Desktop Board Features Hi-Speed USB 2.0 Support The Desktop Board supports up to 12 USB 2.0 ports (six ports routed to the back panel and six ports routed to three internal headers) via ICH10R. USB 2.0 ports are backward compatible with USB 1.1 devices. USB 1.1 devices will function normally at USB 1.1 speeds. USB 2.0 support requires both an operating system and drivers that fully support USB 2.0 transfer rates. Disabling Hi-Speed USB in the BIOS reverts all USB 2.0 ports to USB 1.1 operation. This may be required to accommodate operating systems that do not support USB 2.0. IEEE 1394a Support The board includes an IEEE 1394a Controller that provides two IEE1394a ports: one is assessable through an onboard header and the other is available through a back panel connector. ATA Support The board includes seven ATA interface connectors: • One PATA connector that supports two devices • Five SATA connectors that support one device each • One eSATA connector PATA Interface The board's discrete PATA controller provides one bus-mastering PATA interface that is accessible through a standard PATA (IDE) connector. The PATA interface supports the following modes: • Programmed I/O (PIO): the processor controls data transfer. • 8237-style DMA: DMA offloads the processor, supporting transfer rates of up to 16 MB/s. • Ultra DMA: DMA protocol on the ATA bus supporting host and target throttling and transfer rates of up to 33 MB/s. • ATA-66: DMA protocol on the ATA bus supporting host and target throttling and transfer rates of up to 66 MB/s. ATA-66 protocol is similar to Ultra DMA and is device driver compatible. • ATA-100: DMA protocol on the ATA bus allows host and target throttling. NOTE ATA-66 and ATA-100 are faster timings and require a specialized cable to reduce reflections, noise, and inductive coupling. 19