Intel E5345 Data Sheet - Page 32
Quad-Core Intel® Xeon® Processor X5300 Series V, Static
UPC - 735858191418
View all Intel E5345 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Electrical Specifications Figure 2-5. Quad-Core Intel® Xeon® Processor X5300 Series VCC Static and Transient Tolerance Load Lines Vcc [V] 0 V ID - 0.000 Icc [A] 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 V ID - 0.020 V ID - 0.040 V ID - 0.060 VCC M axim um V ID - 0.080 V ID - 0.100 V ID - 0.120 V ID - 0.140 V ID - 0.160 V ID - 0.180 VCC T ypical VCC M inim um V ID - 0.200 Notes: 1. The VCC_MIN and VCC_MAX loadlines represent static and transient limits. Please see Section 2.13.2 for VCC overshoot specifications. 2. Refer to Table 2-12 for processor VID information. 3. Refer to Table 2-13 for VCCStatic and Transient Tolerance 4. The load lines specify voltage limits at the die measured at the VCC_DIE_SENSE and VSS_DIE_SENSE lands and the VCC_DIE_SENSE2 and VSS_DIE_SENSE2 lands. Voltage regulation feedback for voltage regulator circuits must also be taken from processor VCC_DIE_SENSE and VSS_DIE_SENSE lands and VCC_DIE_SENSE2 and VSS_DIE_SENSE2 lands. Please refer to the appropriate platform design guide for details on VR implementation. Table 2-14. AGTL+ Signal Group Specifications Symbol Parameter Min Typ Max Units Notes1 VIL Input Low Voltage -0.10 0 GTLREF-0.10 V VIH Input High Voltage GTLREF+0.10 VTT VTT+0.10 V VOH Output High Voltage VTT - 0.10 N/A VTT V RON Buffer On Resistance 10.00 11.50 13.00 W ILI Input Leakage Current N/A N/A +/- 200 μA 2,4,6 3,6 4,6 5 7,8 Notes: 1. Unless otherwise noted, all specifications in this table apply to all processor frequencies. 2. VIL is defined as the maximum voltage level at a receiving agent that will be interpreted as a logical low value. 3. VIH is defined as the minimum voltage level at a receiving agent that will be interpreted as a logical high value. 4. VIH and VOH may experience excursions above VTT. However, input signal drivers must comply with the signal quality specifications. 5. This is the pull down driver resistance. Refer to processor I/O Buffer Models for I/V characteristics. Measured at 0.31*VTT. RON (min) = 0.225*RTT. RON (typ) = 0.250*RTT. RON (max) = 0.275*RTT. 6. GTLREF should be generated from VTT with a 1% tolerance resistor divider. The VTT referred to in these specifications is the instantaneous VTT. 7. Specified when on-die RTT and RON are turned off. VIN between 0 and VTT. 8. This is the measurement at the pin. 32 Quad-Core Intel® Xeon® Processor 5300 Series Datasheet