Intel SC5300AF2 User Guide - Page 21
Embedded CLI (Telnet), Configuring the Embedded CLI (Telnet) Feature
UPC - 735858171663
View all Intel SC5300AF2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Embedded CLI (Telnet) Configuring the Embedded CLI (Telnet) Feature Run the Server Configuration Wizard (SCW) on the Intel Server Deployment Toolkit CD to configure the Embedded CLI Telnet Server. The SCW allows you to: • Enable the Telnet Server in firmware • Configure the Telnet port number Using the Embedded CLI (Telnet) Feature The firmware on the Advanced Edition module includes a telnet server. The telnet server provides you with both in-band and out-of-band monitoring and control of the server by using Intel's proprietary Command Line Interface (CLI) syntax called Common CLI (CCLI). The telnet server also allows you to establish a Serial Over LAN (SOL) session. To use the embedded CLI feature, do the following: 1. Connect to the Telnet server. For example, to Telnet to a server at IP address 222.222.222.36 from the command prompt, type the following: Telnet 222.222.222.36 2. Log-in to the server. The Telnet server will ask for the BMC user name and password for LAN channel 3 (this is the NIC attached to the Advanced Edition module). (Use the SCW to configure the user names and passwords.) The server responds with the CLI prompt: CLI> 3. Type a CLI command (the CLI syntax is listed in Appendix A on page 26). For example: CLI>health The server return codes and responses are listed in Appendix A on page 26. NOTE The CLI syntax for the embedded Telnet server is slightly different than the syntax defined in the IPMI 1.5 specification for terminal mode CLI. Intel® Management Module Installation and User's Guide 21