Intel SCB2SCSI Product Guide - Page 27
CAUTION, fan cannot be used in a 1U server chassis.
View all Intel SCB2SCSI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
CAUTION Use care when closing the locking lever-do it slowly. 9. Slowly close the locking lever (A) until it contacts tab (B). A B OM11709A Figure 12. Closing the Locking Lever ✏ NOTE When using the boxed Intel Pentium III processor, compatible with the SCB2 server board, it will come with a fan for the processor heat sink. This fan cannot be used in a 1U server chassis. If you are integrating a 2U chassis, proceed to the next step. 10. Following the instructions provided with the processor, install the fan on the processor heat sink. 11. Connect the fan to (A) if it is on the primary processor or to (B) if it is on the secondary processor. A CPU 1 Fan B CPU 2 Fan OM12163 Figure 13. Connecting the Heat Sink Fan Installation Procedures 27
Installation Procedures
27
CAUTION
Use care when closing the locking lever—do it slowly.
9.
Slowly close the locking lever (A) until it contacts tab (B).
OM11709A
A
B
Figure 12. Closing the Locking Lever
NOTE
When using the boxed Intel Pentium
III
processor, compatible with the
SCB2 server board, it will come with a fan for the processor heat sink. This
fan cannot be used in a 1U server chassis.
If you are integrating a 2U
chassis, proceed to the next step.
10. Following the instructions provided with the processor, install the fan on the processor heat
sink.
11. Connect the fan to (A) if it is on the primary processor or to (B) if it is on the secondary
processor.
OM12163
B
A
CPU 1 Fan
CPU 2 Fan
Figure 13. Connecting the Heat Sink Fan