Intermec PB42 Vehicle Power Install Kit Installation Instructions - Page 9

8 Tighten the nut installed in Step 2 to secure the washers and cables firmly in place. 9 Repeat Steps 2 through 8 for the negative (brown) wire from the battery cable, connecting the negative cables to the negative (-) battery terminal. Connecting to the Top Battery Terminal 1 Remove the battery clamp posts from the vehicle battery terminals. Positive battery terminal Vehicle battery + - Washers Nut Red wire (positive) Gray power cable Positive battery cable 5/16" x 1-1/2" post Fuse link Brown wire (negative) 2 Install a 5/16-inch x 1-1/2-inch post and nut (provided) on each of the battery terminals, and tighten the nut securely. 3 Place a 3/8-inch washer onto the extended end of each battery clamp bolt. 4 Slide the positive (red wire) fuse link terminal ring from the battery cable onto the positive (+) battery clamp bolt. 5 Place another 3/8-inch washer onto the battery clamp bolt. 6 Thread another 3/8-inch nut onto the battery clamp bolt, and tighten the nut. 7 Repeat Steps 2 through 6 for the negative (brown) wire from the battery cable, connecting the wire to the negative (-) battery terminal. Vehicle Power Install Kit Installation Instructions 9