Intermec PM4i PM4i Peel-Off (Self-Strip) Kit Installation Instructions - Page 3

Setup, Ser-com,uart1, Print Defs, Lts Adjust - calibration

Get Intermec PM4i PDF manuals and user guides View all Intermec PM4i manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

4 Close the side door and raise the Peel-off kit by the handle. 5 Adjust the Label Taken Sensor (LTS) so that the media feeds correctly. If you are using Fingerprint: a Press the Setup key to enter the Setup menu. SETUP: SER-COM,UART1 b Use the Right arrow key to browse the Setup menu. Once you get to the Print Defs screen, press the Enter key to enter the Print Defs screen. c Press the Right Arrow key until you get to the LTS screen and press the Enter key to enter the LTS Adjust screen. PRINT DEFS: LTS ADJUST d Press the Enter key to self-calibrate the LTS. e Wait for the prompt to remove your test label, then remove the label. After the label has been removed, press the Enter key. f Your printer is configured for Peel-Off mode. Press the Setup key to exit the Setup menu.

  • 1
  • 2
  • 3
  • 4
4
Close the side door and raise the Peel-off kit by the handle.
5
Adjust the Label Taken Sensor (LTS) so that the media feeds correctly.
If you are using Fingerprint:
a
Press the
Setup
key to enter the Setup menu.
b
Use the
Right
arrow key to browse the Setup menu. Once you get to
the Print Defs screen, press the
Enter
key to enter the Print Defs
screen.
c
Press the
Right Arrow
key until you get to the LTS screen and press
the
Enter
key to enter the LTS Adjust screen.
d
Press the
Enter
key to self-calibrate the LTS.
e
Wait for the prompt to remove your test label, then remove the label.
After the label has been removed, press the
Enter
key.
f
Your printer is configured for Peel-Off mode. Press the
Setup
key to
exit the Setup menu.
SETUP:
SER-COM,UART1
PRINT DEFS:
LTS ADJUST