Intermec PX4i Important 802MIG2 Information! - Page 1

Important 802MIG2 Information For Users in the United States and Canada This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that can cause undesired operation. Federal Communications Commission Compliance This equipment is intended for operation in a commercial environment, in compliance with the requirements for a Class B digital device, pursuant to Part 15 of the FCC Rules, and it must not be used in a residential environment. It generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instruction manual, it may cause interference to radio communications. If this equipment causes interference, the user will be required to correct the interference at the user's own expense. Operation Warning: The user must stay at least 20 cm (8 in) away from the antenna of this device, when the device is in use in access points and other hosts, where higher gain antennas may be used. Installation Warning: To comply with the FCC's RF exposure requirements and minimize health hazards: Host devices with higher gain antennas such as access points must be installed in such a way that the user will be at least 20 cm (8 in) away from the antenna, when the device is in use. The installers should not forget that the burden of maintaining this distance is on the installer and not the user. The antennas should be installed in a manner that will comply with this requirement. Changes or modifications not expressly approved by Intermec could void the user's authority to operate this equipment. Note: To maintain compliance with FCC Rules, the input/output (I/O) cables that interconnect between the device and any peripheral must be as specified by Intermec. Industry Canada Compliance This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. This device requires a radio license, unless it is used totally inside a building. (The user must obtain this license.) Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada. Cet appareil exige une license radio à moins d'être entièrement installé dans un bâtiment. (L'utilisateur doit obtenir cette license.) For Users Outside of the United States and Canada The Intermec product you purchased contains a Mode 802MIG2 transceiver module. This module transmits and receives data using a 2.4 GHz Direct Sequence Spread Spectrum system. Please check the Intermec web site for additional documentation at www.intermec.com. Hereby, Intermec Technologies Corporation declares that this Model 802MIG2 is in compliance with the essential requirements and other relevant provisions of R&TTE Directive (1995/5/EC). This product has been assessed to the following standards: • ETSI EN 300 328-2 v1.2.1 (2001-12) • ETSI EN 301 489-17 v1.1.1 (2001-09) • EN 60950:1992 (incl. Amdt. 1-4,11) The original Declaration of Conformity is available on the Intermec Technologies Corporation web site at www.intermec.com. This product transmits electromagnetic waves at 2.4 GHz frequency range. It has been tested and found compliant with U.S. (OET Guide 65) and Canadian (RSS 102) RF exposure regulations. There are no regulations covering this product type in the European Union at this time. The transmitter module's output power is 11.6 mW. The product using this module is intended for business and industrial environments. It should not be used in residential environments or by children. 0981 This product is marked with this logo and uses radio frequency bands that are not harmonized throughout the European Union. The following table indicates the areas of intended use of the equipment and any known restrictions.