Invacare 7714P Owners Manual - Page 1

Floor Base and Fixed Trapeze Assembly, Installation and Operating Instructions Model Nos. 7714P and G7740P SAVE THESE INSTRUCTIONS NOTE: Check ALL parts for shipping damage. In case of shipping damage, DO NOT use. Contact Dealer/Carrier for further instructions. Safety Summary To ensure the safe and proper installation of the Floor Base and Fixed Trapeze, these instructions MUST be followed: ƽ WARNING DO NOT install this equipment without first reading and understanding this instruction sheet. If you are unable to understand the warnings, cautions and instructions, contact a healthcare professional, dealer or technical personnel if applicable, before attempting to install this equipment - otherwise, injury or damage may occur. The Fixed Trapeze MUST ONLY be installed onto beds with metal framed headboards. The Fixed Trapeze used in conjunction with a bed, can assist an individual weighing up to 250 lbs. (114 kg.). The Fixed Trapeze is designed to provide support, increase stability and assist the user when repositioning himself/herself in bed. Use the trapeze as an assistive device only. The trapeze is not designed to support the total body weight of an individual or to be used as an assist device when transferring into or out of a bed. ƽ INSTALLATION WARNINGS After ANY adjustments, repair or service and BEFORE use, make sure that all attaching component parts are secure. DO NOT INSTALL OR ADJUST TRAPEZE OF AN OCCUPIED BED. DO NOT attach swivel trapezes to the floor base. This may cause the floor base to tip over, causing injury to the patient and/or assistants. Floor Base MUST be positioned under the bed at the headboard position. Ensure that the snap buttons fully protrude through the adjustment hole of the floor leg assembly. This ensures that the Floor Base is properly installed and securely locked in position. ƽ ACCESSORIES WARNING Invacare products are specifically designed and manufactured for use in conjunction with Invacare accessories. Accessories designed by other manufacturers have not been tested by Invacare and are not recommended for use with Invacare products. Assembling the Floor Base NOTE: For this procedure, refer to FIGURE 1 on page 2. 1. Install the ʺAʺ frame into the floor base assembly with the snap buttons facing the short length of the floor base. 2. Depress the snap button on one leg of the ʺAʺ frame and slide it into the floor base assembly until an audible ʺclickʺ is heard. For more information regarding Invacare products, parts, and services, please visit www.invacare.com Part No 1013153 1 Floor Base and Fixed Trapeze