Invacare 7714P Owners Manual - Page 2

3. Repeat STEP 2 for the opposite side. NOTE: Ensure that the snap buttons fully protrude through the adjustment hole of the floor leg assembly. This ensures that the Floor Base is properly installed and securely locked in position. 4. Attach trapeze to floor base/bed end. Refer to Attaching Trapeze to Floor Base/Bed End on page 2. Snap Buttons Leg Short Length "A" Frame Leg Floor Base Assembly FIGURE 1 Assembling the Floor Base Attaching Trapeze to Floor Base/Bed End NOTE: For this procedure, refer to FIGURE 2 on page 3. 1. Perform one of the following: • Floor Base i. Position the lower bed bracket in the center of the bottom rail with the tubular hook facing DOWN. ii. Tighten wing nuts to secure lower bed bracket onto bottom rail. • Bed End i. Position the lower bed bracket in the center of the bottom bed frame with the tubular hook facing UP. ii. Tighten wing nuts to secure lower bed bracket onto bottom bed frame. NOTE: Position the lower bed bracket in the center of the bottom bed frame. If interference from the bed drive shaft, the trapeze brackets MUST be positioned as close to the center of the bed as possible. 2. Place the trapeze on a flat surface for easier installation of the upper bed bracket. 3. Loosen wing nuts on the upper bed bracket and slide the bracket approximately ¾ of the way up on the offset bar. 4. Hand tighten the wing nuts just enough to hold the upper bed bracket in place on the offset bar. 5. Install trapeze assembly into the socket of the lower bed bracket. 6. Position the tubular hook of the upper bed bracket so it rests on the top rail of floor base/bed end. 7. Securely tighten the wing nuts to secure the upper bed bracket to the top rail of the floor base/bed end. NOTE: When using the floor base in conjunction with a bed, the long legs of the floor base should slide under the bed. 8. Adjust the height and/or position of the grab bar. Refer to Adjusting the Grab Bar on page 2. Adjusting the Grab Bar NOTE: For this procedure, refer to FIGURE 2 on page 3. Height 1. Position any of the lower chain links onto the ʺSʺ hook. Position 1. Loosen trapeze key by turning counterclockwise. 2. Slide the clamp to desired position on the offset bar. 3. Secure the trapeze clamp to the offset bar by turning the key clockwise. Floor Base and Fixed Trapeze 2 Part No 1013153