Invacare M41RSOLID20R Owners Manual - Page 47
Replacing Heel Loops
View all Invacare M41RSOLID20R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
SECTION 10-FRONT RIGGINGS Model PH904A and PHAL4A NOTE: For this procedure, refer to FIGURE 10.3. NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way. 1. Loosen, but do not remove the lug bolt and locknut that secure the lower footrest to the footrest support. 2. Reposition the lower footrest to the desired height. Footrest Support Lug Bolt Locknut 3. Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support. 4. Repeat STEPS 1‐3 for the opposite side of the wheelchair footrest, if necessary. Lower Footrest FIGURE 10.3 Adjusting Footrest Height Model PH904A and PHAL4A Replacing Heel Loops NOTE: For this procedure, refer to FIGURE 10.4. 1. Note the position of hex bolt, coved washers and locknut for reinstallation. Locknut Coved Washer 2. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support. 3. Remove the lower footrest. 4. Remove the phillips® bolt, spacer and locknut that secure the existing heel loop to the lower footrest. Coved Washer Footrest Support Lower Footrest Hex Bolt Phillips Bolt Spacer Heel Loop 5. Slide the existing heel loop off the lower footrest. Locknut 6. Replace heel loop. 7. Reverse STEPS 1‐6 to reassemble. FIGURE 10.4 Replacing Heel Loops NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the spacer is secure. Part No. 1143206 47 Pronto® M41 with SureStep®