Invacare R51LXP Owners Manual - Page 37

SECTION 6-FRONT RIGGINGS Adjusting Calfpads 1. Turn calfpad towards the outside of the wheelchair. 2. Slide calfpad up or down until desired position is obtained. NOTE: If one of the top two calfpad adjustment positions is being used, the legrest will need to be raised to avoid interference with the front stabilizers while going over obstacles or going up and down ramps. Refer to Raising/Lowering Elevating Legrests on page 36. 3. Turn the calfpad toward the inside of the wheelchair. Release Lever Calfpad Rotated for Height Adjustment Calfpad Top Two Calfpad Adjustment Positions FIGURE 6.6 Raising/Lowering Elevating Legrests and/or Adjusting Calfpads Adjusting/Replacing Telescoping Front Rigging Support NOTE: For this procedure, refer to FIGURE 6.7 on page 38. NOTE: When adjusting the telescoping front rigging support depth, ensure the footplate does not interfere with the caster wheel rotation. 1. Lift up on the crossbraces until they release from the H-blocks on the wheelchair frame. 2. Remove the long socket bolt and locknut that secure the front H-block and spacer to the wheelchair frame and telescoping front rigging support. 3. Remove the front, and rear short socket bolts and the two locknuts that secure telescoping front rigging support to wheelchair. Part No. 1106645 37 R51™and R51LXP