JBL JSR 675 Owners Manual English - Page 18

4. PRESET SCAN BUTTON Button for scanning preset station frequencies (see page 15). 5. NUMERIC BUTTONS These buttons can be used for preset tuning in TUNER mode. Preset tuning: Press the TUNER button to change the input function of the receiver to TUNER and then select one of the 30 preset locations. 6. CD FUNCTION BUTTONS For a CD PLAYER: DISC (DISC SKIP, this is available for Harman Kardon CD changers), (play), (pause), (stop), (backward skip), (forward skip), 1-2 and INTRO buttons are available. When selecting a disc, press the DISC button. The A-B button is used to repeat a specific passage. 7. CASSETTE DECK FUNCTION BUTTONS - For a cassette deck: (pause/record), (stop), (record), (reverse play), (forward play), (rewind), (fast forward) buttons are available. This will only work with some Harman Kardon cassette decks. 8. DELAY TIME BUTTON This button operates only in DOLBY PRO LOGIC and THEATER/STADIUM modes. In these modes, the output signal from the surround speakers is delayed slightly from that of the front speakers. Select appropriate delay time to achieve the best surround sound effect. For Dolby Surround sound, we recommend a 20ms delay. The time is changed as below, when the button is pressed in succession. DOLBY PRO LOGIC 16ms 18ms 20ms 22ms 24ms 26ms 28ms 30ms THEATER/STADIUM MODE 8ms 16ms ....... 88ms 96ms 9. INPUT FUNCTION SELECTOR Press the button to select the desired input function. The available buttons are CD, TUNER, TAPE 1, TAPE 2, TV/AUX, VCR 1, VCR 2, and PHONO. 10. CENTER LEVEL UP/DOWN BUTTONS Use these buttons to adjust the sound level of the center speaker to that of the front speakers. These buttons work only in DOLBY PRO LOGIC and DOLBY 3 STEREO mode. These buttons do not work in PHANTOM mode. 11. CENTER MODE BUTTON Selects the center mode (see page 14). 12. TEST TONE BUTTON Generates test sounds in all channels (Left, Center, Right and Surround) in succession. 13. REAR LEVEL UP/DOWN BUTTONS These buttons operate only in DOLBY PRO LOGIC THEATER and STADIUM mode. Use these buttons to adjust the sound level of the surround speakers. Set the MASTER VOLUME control at the desired level and press the up or down button until you get the optimum surround effect at your listening position. 14. MASTER VOLUME BUTTONS Adjust the overall (front, center, and rear) volume level. 15. DISPLAY BUTTON Press once and the display dims, press again and it turns off. Press a third time and it goes on. 16. SLEEP BUTTON Sets the receiver to automatically turn off after 10, 20, 30, 60, or 90 minutes. Each time the button is pressed, the setting is advanced as below. 10 min 20 min 30 min 60 min 90 min OFF The display will dim when the sleep function has been set. 17. MUTE BUTTON Press this button to silence the speakers temporarily. The volume indicator blinks. Press again to restore the same listening level as before. 18. BATTERY COMPARTMENT This battery case is provided as the power source for the commander. To remove the cover, press it down with your thumb and pull it toward the back side. Two UM-3, size "AA" or R6 1.5V dry batteries are used. When loading the batteries, make sure that the polarity is correct. Remove the batteries from the case if the remote commander will not be used for a long time. 17