JVC DT-3D24G1U DT-3D24G1U Operation Manual - Page 18

Setting the menu (MAIN MENU/SET-UP MENU) Menu Operations 1 Display the menu. To display the MAIN MENU ➔ Press MENU button. To display the SET-UP MENU ➔ Press button while holding button. MAIN MENU Item being selected Operation guide SET-UP MENU 2 Press buttons to select an item, then press button. ● For some items, adjustments will be made by pressing . 3 Press buttons to select an item, then press buttons to make adjustments. MAIN MENU Ex. When "MARKER" is selected. 4 Press MENU button to finish the menu operation. ● Pressing MENU button repeatedly deactivates the display of the menu. Menu Transition Diagram MAIN MENU PICTURE FUNCTION BACK LIGHT 3G SDI LEVEL B SDI DUAL LINK 3D SETTING ASPECT MARKER AUDIO SETTING SCOPE SETTING SYNC FUNCTION SET-UP MENU APERTURE APERTURE LEVEL I/P MODE sub menu reset BALANCE E.AUDIO GROUP LEVEL METER SETTING NO SYNC ACTION DELAY TIME LOW LATENCY SDI FORMAT 1 SDI FORMAT 2 DVI FORMAT 1 DVI FORMAT 2 SINGLE IMAGE FRAME SYNC. FAR LIMIT NEAR LIMIT L. INTENSITY LEVEL METER ch BAR TYPE REFERENCE LEVEL OVER LEVEL BAR BRIGHTNESS PEAK HOLD GAIN SIZE POSITION TRANSPARENT AUTO OFF WAVE DISPLAY WAVE FILTER WAVE OVER LEVEL AREA MARKER MARKER ASPECT SAFETY MARKER SAFETY AREA FRAME CENTER MARKER LINE BRIGHTNESS R-AREA MARKER R-MARKER ASPECT R-SAFETY MARKER R-SAFETY AREA MARKING LEVEL FUNCTION SETTING PICTURE SUB ADJ. H POSITION ADJ. WHITE BALANCE SET. 3D H POSITION sub menu reset CONTRAST BRIGHT CHROMA sub menu reset sub menu POSI. TALLY SELECT SD4:3 LARGE DIMMER REMOTE SETTING INFORMATION CONTROL LOCK DVI INPUT SEL. SDI FORMAT all reset POSITION SOURCE ID CHARACTER SET. STATUS DISPLAY TIME CODE CRC ERROR SUB HOUR METER MODEL VERSION HOUR METER SERIAL TYPE PARALLEL TYPE PIN1 PIN2 PIN3 PIN4 PIN5 PIN6 PIN7 PIN8 GAMMA COLOR TEMP. R DRIVE G DRIVE B DRIVE R CUT OFF G CUT OFF B CUT OFF sub menu reset ● The menu automatically disappears in about 30 seconds after the previous operation. ● Some items may not appear on the menu depending on the input or the input signal. ● The items controlled by the MAKE system do not appear on the menu. 18