JVC GY-DV500U GY-DV500 User Manual - PDF (4,089KB) - Page 47

6. SETTING AND ADJUSTMENTS BEFORE SHOOTING 6-7 Audio Input Signal Selection VF OFF ZEBRA SKIN ON AREA AUTO WHITE ACCU FOCUS VTR AUDIO LEVEL CH-1 TAKE Microphone input connector FILTER 1 3200k 2 5600k 3 5600k+ND SHUTTER STATUS MENU ALARM MONITOR AUTO IRIS FULL AUTO BLACK BACK L NORMAL SPOT L STRETCH NORMAL COMPRESS LOLUX PRST A B ON KNEE OFF AUTO BARS CAM HML SAVE STBY VTR GAIN OUTPUT WHT.BAL NG POWER ON OFF OPERATE/WARNING RESET MONITOR SELECT CH-1 AUDIO CH-2 LEVEL LIGHT ON OFF COUNTER CTL TC UB CH-1 AUDIO CH-2 LEVEL AUTO MANUAL AUDIO SELECT AUDIO INPUT CH-1 CH-2 FRONT REAR CH-1 AUDIO LINE/MIC switch EARPHONE DV CH-1 AUDIO IN CH-2 LINE MIC LINE MIC DC INPUT +48V ON +48V ON TALLY DC OUTPUT CH-2 AUDIO LINE/MIC switch CH-1 AUDIO INPUT connector CH-2 AUDIO INPUT connector CH-1 AUDIO INPUT switch CH-2 AUDIO INPUT switch The GY-DV500 is provided with the microphone connector on the front section and the two AUDIO INPUT connectors at the rear section for audio input. On the other hand, two channels of sound can be recorded on the tape in digital PCM format. Using the AUDIO INPUT switch, select for each channel (CH1 and CH2) whether the sound to be recorded should be the sound from the microphone connector on the front section or the sound from the AUDIO INPUT connectors on the rear section. Ⅲ Selecting the CH-1 channel input sound Make the selection using the CH-1 AUDIO INPUT switch. FRONT : The sound from the microphone connector on the front section is recorded on the CH-1 channel. REAR : The sound from the CH-1 AUDIO INPUT connector on the rear section is recorded on the CH-1 channel. Ⅲ Selecting the CH-2 channel input sound Make the selection using the CH-2 AUDIO INPUT switch. FRONT : The sound from the microphone connector on the front section is recorded on the CH-2 channel. REAR : The sound from the CH-2 AUDIO INPUT connector on the rear section is recorded on the CH-2 channel. Ⅲ Selecting the front section's microphone connector A microphone (phantom microphone, etc.) requiring +48 V power supply or other type of camera microphone (monaural) can be connected. • In accordance with the connected microphone, specify the phantom microphone or other type of microphone using the Camera Setup Menu item CAM MIC +48V. • The reference input level is -60 dBs. Ⅲ Selection of rear audio input connectors Select the audio signal input to the AUDIO INPUT connector using the [LINE/MIC] switch. Make settings for the CH-1 and CH-2 AUDIO IN connectors separately. LINE : Set to this position when connected to audio equipment, etc. The reference input level is +4 dBs. MIC : Set to this position when using a monaural microphone. The reference input level is -60 dBs. MIC +48 V : Set to this position when a microphone (phantom microphone) requiring +48 V DC power supply is connected. CAUTION: When connecting a component that does not require +48 V power supply, make sure that the LINE/MIC switch is not set to MIC +48V. When using the microphone on the front section, set the Camera SETUP screen item "CAM, MIC, 48V" to "OFF". Neglecting this could cause damage to the connected component. 47