JVC GY-DV5100U Instruction Manual - Page 65

9. USING EXTERNAL COMPONENTS 9-1 Connecting a Video Component with DV Connector Connecting the GY-DV5100 to another video component equipped with DV I/O connector (IEEE1394 standard) using a DV cable (optional) enables dubbing of digital signals with high picture quality and high-quality sound. Rear section of GY-DV5100 PHONES DV INT DC OUT DC IN TALLY CH-1 CH-2 REAR AUDIO IN DV connector DV cable (VC-VDV204 (4P-4P), VC-VDV206 (4P-6P)) Video component with DV Connector DV connector When Using the GY-DV5100 as Playback Unit (Dubbing to Another Video) 1. Connect the units with the DV cable. 2. Switch the DV/INT selector switch on the rear of the camera to DV. EDITSEARCH FILTER 1 3200K 2 5600K 1/8 ND .3 5600K .4 5600K 1/64 ND SHUTTER STATUS MONITOR MENU AUTO IRIS FULL AUTO BACK L NORMAL SPOT L BLACK LOLUX STRETCH NORMAL COMPRESS MODE VTR CAM POWER VTR ON OFF OPEN CH-1 AUDIO LEVEL CH-2 LCD BRIGHT FRONT REAR CH-1 CH-2 AUDIO IN AUDIO SELECT CH-1 CH-2 AUTO MANUAL DISPLAY PULL OPEN MODE VTR CAM 3. Turn ON both units. 4. Place the GY-DV5100 in the VTR MODE. Press the MODE switch upward to turn on the VTR indicator. 5. Insert the videocassettes. GY-DV5100: Insert the recorded videocassette. Recording unit: Insert the videocassette to be dubbed to. MODE switch ● Dubbing still images makes the images coarser. In addition, noise may appear in the sound. DV INT 6. Press the PLAY button on the GY-DV5100 to start playback. 7. Start recording on the recording unit. For details, see the instructions to the unit used for recording. 8. When dubbing is completed. Stop recording on the recording unit, and then press the STOP button on the GY-DV5100 to stop playback. MEMO: ● Turn the camera off before switching DV/INT. ● The operation methods differ with the characteristics and specifications of the connected equipment. Even if connection is possible, operation or data communication may sometimes be impossible to perform. ● If block noise appears or the sound falls out, try to disconnect and then connect the DV cable again, or turn the power to the GY-DV5100 off and then on again. ● When connecting to a D-9 (digital-S) component with an IEEE1394 connection, the date and time data are not output from the D-9 component. Also, the date and time data cannot be recorded on the D-9 component. When making an IEEE1394 connection with a D-9 component, install SA-DV60 on the device. ● If the power to the component connected to the DV connector is turned on, or the video input is changed, noise may appear in the audio. When these operations have to be performed, reduce the sound volume of the audio component, speaker, etc., connected to the GY-DV5100 to a minimum. ● When using the TC DUPLICATE mode of BR-DV600A, set Menu No. 416 [NON DROP/DROP] of BR-DV600A according to the framing mode (Drop/Non-drop) of the tape to be played back on this unit. 65