JVC HAW600RF Instructions - Page 13

ENGLISH Troubleshooting What appears to be trouble is not always serious. Check the following points before calling a service center. Symptom No sound comes out at all. No sound comes out from R-channel. Sound is distorted. Sound is noisy. Cannot charge the battery. Cause/Remedy • Turns on the power of the headphones. • Start playback on the AV equipment connected to the base station. • Check the connection between the base station and the AV equipment. • Turns up the volume of the headphones or the connected AV equipment to an appropriate level. • Fully charge the headphones' battery. • Check the connection between the base station and the AV equipment. • Sound comes out only of L-channel when the base station is connected to the monaural audio output. Convert the mini plug to the base station from stereo to monaural with the plug adaptor (not supplied). • The headphones' battery will soon run out. Fully charge the battery. • The volume of the headphones and/or the connected AV equipment is too high. Adjust their volume to an appropriate level. • The headphones' battery will soon run out. Fully charge the battery. • Switch the base station channel to another and press AUTO SCAN on the headphones. • The volume of the connected AV equipment is too low. Adjust the volume as high as possible without causing distortion. • Too far from the base station. Use the headphones within the range of the base station (see page 8). • Check the contact of the charging terminals on the base station and the headphones. • Check the polarity of the battery. • The cycle life of the battery ended. Replace with the new battery (see page 6). 9