JVC HR-S5900U Instructions - Page 55
Changing, Remote Control
UPC - 046838158841
View all JVC HR-S5900U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Changing Remote Control Code 2 POWER S VIDEO VIDEO (MONO)L-AUDIO-R REC LINK S-VHS ET A.DUB INSERT PLAY REW - FF + CH- /+ PUSH / TURN 24HR QUICK PROGRAM REC PAUSE STOP/EJECT 1 -1, 3 1 2 3 2 4 5 6 2 1 - 7 8 9 0 4 1 EN 55 This Remote is capable of transmitting two control codes; one set to respond to A code control signals and another set to respond to B code control signals. This Remote control is preset to send A code signals because your VCR is initially set to respond to A code signals. You can easily modify your VCR and the Remote to respond to B code signals. When using two JVC VCRs, set two VCRs and their Remotes to different codes, so that you can operate these VCRs separately. Set remote control code for Remote 123 1 Press and hold A/B. Press the Number key "2". Press OK, and release A/B. ● The Remote now can transmit B code control signals. Check remote control code for VCR 2 Press and hold 3 on the VCR for more than 5 seconds while the VCR is turned off. The code currently set appears on the display panel. Change code for VCR 3 Press any key on the Remote. ● The VCR now responds to B code control signals. ● To set the Remote and the VCR back to A code control signals, repeat the same procedure as 2 shown above except pressing the Number key "1" in step of . 1 To control two VCRs with the same Remote You can control two JVC VCRs by switching the remote control code for the Remote between A and B (੬ step 1), keeping two VCRs to different control codes. ● Press the Number key "1" for A code control signals and the Number key "2" for B code control signals. (To change only the remote control code for the Remote, DO NOT perform steps 2 and 3 .) 3 3 1 - (Ex.) To set Remote to B code: MBR SET A/B 2 ENTER/OSD 3 OK Release Hold Press in succession down