JVC HR XVC1U Instructions - Page 31

Timer recording can be programmed on-screen with the remote control. The built-in timer allows automatic unattended recording of up to 8 programs within 1 month. DVD MENU DISPLAY SP/EP PLAY MODE MARKER A.TRK SUB TITLE ZOOM RETURN OPEN/ CLOSE C.RESET ZERO RETURN ANGLE SEARCH MODE TITLE REPEAT A-B TV POWER INPUT 0 REW TIMER TV/VCR TV VOL PLAY FF REC SKIP /INDEX STOP TV/VCR CH + PAUSE SKIP /INDEX SET ENTER/ SELECT SET UP MENU OSD TV/VCR CH - SLOW A.MONITOR SET CANCEL SSEKAIRPCH NOTE: • If the clock symbol( ) blinks when the timer recording ended, the TV program has not been completely recorded because of an insufficient tape supply. In this case, press TIMER to cancel the timer program or press EJECT to remove the cassette tape. • During timer recording standby mode, the VCR mode cannot be selected. To use the VCR, press TIMER at first, then press VCR to change to VCR mode. After you use the VCR, press TIMER again to put the VCR into timer recording standby mode. • If you press TIMER during timer recording, the recording operation will be interrupted. If you press TIMER again within the programmed time, the recording operation will start again. • After a power failure or disconnection of the power plug, all programmed recording settings and time display will be lost upon resumption of power. In this case, reset the clock (see pages 21-23) and reprogram any timer recordings. Timer Recording Preparation: • Make sure TV/VCR/DVD switch has been slided to VCR/DVD. Then press VCR to select the VCR mode. • Load a cassette tape with the erase prevention tab intact. • Press OSD to verify that the time and date are correct.(see page 29). Example: Program a timer recording for the 26th day, channel 125 (CATV), 11:00 - 11:30 PM on timer program number 1 (Tape speed: EP). 1 Press SETUP MENU. Select the TIMER REC SET option, then press ENTER. MENU TIMER REC SET AUTO REPEAT ON OFF SAP ON OFF SURROUND ON OFF CH SET UP SYSTEM SET UP 〈+/-/ENTER/MENU〉 2 Press SET + or - to select one of the program line, then press ENTER. DATE START END CH 〈+/-/ENTER/CANCEL/MENU〉 3 Press SET + or - to select the date, then press ENTER. DATE START END CH 26(SU 〈+/-/ENTER/CANCEL/MENU〉 4 Set the start time, end time, channel and tape speed as in step 3. NOTE: • Press CANCEL to move cursor backward for correction. • To record from external source set the channel to "L". "L" will appear next to CH 125 (or 69). 5 To enter other programs, repeat step 2 through 4. • To return to the normal screen, press SETUP MENU twice. DATE START END CH 26(SU) 11:00PM 11:30PM125 EP ENTER/CANCEL/MENU〉 DATE START END CH 26(SU) 11:00PM 11:30PM125 EP ENTER/CANCEL/MENU〉 6 Press TIMER. The clock symbol( ) will appear on the display and the VCR stands by for recording. At the same time, VCR mode will change to DVD mode automatically. You can use DVD even if the VCR is in the Timer recording mode. If you do not use the DVD, turn the power off. The timer recording will start at 5 seconds before the time you predetermined. NOTE: • If the clock symbol( ) does not appear on the display in spite of the pressing of TIMER, the cassette may not have been loaded yet.(see page 24) • If the cassette is ejected in spite of the pressing of TIMER , the erase prevention tab of the cassette may have been removed.(see page 24) 31